RLC-115 For Viewsonic Projector Lamp PX702HD
Product Parameter
| Part Numbers | RLC-115 |
| Fittable projector models | For Viewsonic Projector Lamp PX702HD |
| Bulb Type | 220 W |
| Life time | 3000 -4800(Hours) |
| Packing | Carton box with foam |
| Minimum Order quantity | 10 piece |
Product Information
The Viewsonic RLC-115 replacement lamps are compatiable with
PX702HD projectors.The working hour time is:3000-4800 hours,After
repalcing our new lamps,the projector performance can be the same
of the new original one and improve the effect of projection,and
make you feel comfortable while using.
Customer Support
Manufacturers typically have customer support channels, such as
helplines or email support, where customers can reach out with
their queries or concerns regarding projector bulbs. The customer
support team can provide personalized assistance and address
specific issues.
Bulb warranty
Access the Lamp Compartment: Locate the lamp compartment on your
projector. The exact location may vary depending on the projector
model. Usually, it is accessible from the top or bottom of the
projector or through a side panel. Remove any screws or latches
that secure the compartment.
Remove the Old Lamp: Carefully detach the old lamp by following the
instructions provided in the user manual. In some cases, the lamp
may be held in place by screws or clips. Gently release the lamp
and disconnect any cables or connectors attached to it.
Install the New Lamp: Take the new lamp and align it correctly with
the lamp housing. Make sure it fits securely and matches the
connections of the previous lamp. Reconnect any cables or
connectors that were disconnected during the removal process.
Secure the Lamp Compartment: Once the new lamp is in place, secure
the lamp compartment by reattaching any screws or latches that were
removed earlier. Ensure that the compartment is sealed properly to
prevent any dust or debris from entering.
Reset Lamp Timer: After installing the new lamp, it is essential to
reset the lamp timer on the projector. This step varies by
projector model, so refer to the user manual for instructions on
how to reset the lamp timer.
