VT75LP For NEC Projector Lamp LT280 LT380 VT470 VT670 VT676
Product Parameter
| Part Numbers | VT75LP |
| Fittable projector models | For NEC Projector Lamp LT280 LT380 VT470 VT670 VT676 |
| Bulb Type | 180 W |
| Life time | 3000 -5000(Hours) |
| Packing | Carton box with foam |
| Minimum Order quantity | 10 piece |
Play the content
Once the projector is set up and the image is adjusted to your
liking, play the content on the connected video source device. The
projected image should now appear on the screen or wall.
Product Information
The NEC VT75LP replacement lamps are compatiable with LT280 LT380
VT470 projectors.The working hour time is:3000-5000 hours,After
repalcing our new lamps,the projector performance can be the same
of the new original one and improve the effect of projection,and
make you feel comfortable while using.
Bulb warranty
Access the Lamp Compartment: Locate the lamp compartment on your
projector. The exact location may vary depending on the projector
model. Usually, it is accessible from the top or bottom of the
projector or through a side panel. Remove any screws or latches
that secure the compartment.
Remove the Old Lamp: Carefully detach the old lamp by following the
instructions provided in the user manual. In some cases, the lamp
may be held in place by screws or clips. Gently release the lamp
and disconnect any cables or connectors attached to it.
Install the New Lamp: Take the new lamp and align it correctly with
the lamp housing. Make sure it fits securely and matches the
connections of the previous lamp. Reconnect any cables or
connectors that were disconnected during the removal process.
Secure the Lamp Compartment: Once the new lamp is in place, secure
the lamp compartment by reattaching any screws or latches that were
removed earlier. Ensure that the compartment is sealed properly to
prevent any dust or debris from entering.
