VT85LP For NEC Projector Lamp VT480 VT490 VT491 VT495 VT580 VT590
VT595 VT695
Product Parameter
| Part Numbers | VT85LP |
| Fittable projector models | For NEC Projector Lamp VT480 VT490 VT491 VT495 VT580 VT590 VT595
VT695 |
| Bulb Type | 200 W |
| Life time | 3000 -5000(Hours) |
| Packing | Carton box with foam |
| Minimum Order quantity | 10 piece |
Power off the projector
When you're finished using the projector, properly power it off.
Locate the power button on the projector or its remote control and
press it to turn off the projector. Wait for the projector to shut
down completely before disconnecting the power.
Product Information
The NEC VT85LP replacement lamps are compatiable with VT480 VT490
VT491 projectors.The working hour time is:3000-5000 hours,After
repalcing our new lamps,the projector performance can be the same
of the new original one and improve the effect of projection,and
make you feel comfortable while using.
Bulb warranty
Use Proper Tools: Prepare the necessary tools for the installation,
such as a screwdriver or lamp removal tool, as specified in the
user manual. Using the correct tools will ensure a secure and safe
installation.
Access the Lamp Compartment: Locate the lamp compartment on your
projector. The exact location may vary depending on the projector
model. Usually, it is accessible from the top or bottom of the
projector or through a side panel. Remove any screws or latches
that secure the compartment.
Remove the Old Lamp: Carefully detach the old lamp by following the
instructions provided in the user manual. In some cases, the lamp
may be held in place by screws or clips. Gently release the lamp
and disconnect any cables or connectors attached to it.
Install the New Lamp: Take the new lamp and align it correctly with
the lamp housing. Make sure it fits securely and matches the
connections of the previous lamp. Reconnect any cables or
connectors that were disconnected during the removal process.
