LMP-D214 For SONY Projector Lamp VPL-D200 VPL-DX220 VPL-DW240 DX270
Product Parameter
| Part Numbers | LMP-D214 |
| Fittable projector models | For SONY Projector Lamp VPL-D200 VPL-DX220 VPL-DW240 DX270 DX240 |
| Bulb Type | 215 W |
| Life time | 3000-5000(Hours) |
| Packing | Carton box with foam |
| Minimum Order quantity | 10 piece |
Product Information
The SONY LMP-D214 replacement lamps are compatiable with VPL-D200
VPL-DX220 VPL-DW240 projectors.The working hour time is:3000-5000
hours,After repalcing our new lamps,the projector performance can
be the same of the new original one and improve the effect of
projection,and make you feel comfortable while using.
Comment
projector is an electronic device that is used to display visual
content onto a screen or other flat surface. The specific features
and specifications may vary depending on the brand, model, and
intended use of the projector.
Bulb warranty
Access the Lamp Compartment: Locate the lamp compartment on your
projector. The exact location may vary depending on the projector
model. Usually, it is accessible from the top or bottom of the
projector or through a side panel. Remove any screws or latches
that secure the compartment.
Remove the Old Lamp: Carefully detach the old lamp by following the
instructions provided in the user manual. In some cases, the lamp
may be held in place by screws or clips. Gently release the lamp
and disconnect any cables or connectors attached to it.
Install the New Lamp: Take the new lamp and align it correctly with
the lamp housing. Make sure it fits securely and matches the
connections of the previous lamp. Reconnect any cables or
connectors that were disconnected during the removal process.
Secure the Lamp Compartment: Once the new lamp is in place, secure
the lamp compartment by reattaching any screws or latches that were
removed earlier. Ensure that the compartment is sealed properly to
prevent any dust or debris from entering.
