MU04951 filter for Hitachi projector General CP-X308, CP-X400
Projector Filter
Product Parameter
| Part Numbers | MU04951 filter |
| Fittable projector models | for Hitachi projector General CP-X200, CP-X205, CP-X300, CP-X300W,
CP-X305, CP-X308, CP-X400, CP-X417, ED-X30, ED-X32, HCP-800X,
HCP-80X, HCP-880X, Dukane ImagePro 8755G, ImagePro 8755G-RJ,
ImagePro 8781, ImagePro 8782, ImagePro 8912, ImagePro 8913,
ImagePro 8913-W, ViewSonic PJ759, PJ760, 3M X64, X64w, X66. |
| Packing | Carton box with foam |
| Minimum Order quantity | 10 piece |
Points to note
1. Prepare tools
Cleaning the filter requires some basic tools: soft brush, clean
cotton cloth or fine-bristled brush, bottled gas.
2. Power outage or shutdown
Before cleaning, you need to power off the projector or turn it off
for safety.
3. Remove the filter
To remove the projector filter, you need to follow the instructions
or operating guide. Do not use excessive force or you may damage
the filter or machine.
4. Clean the filter
Before cleaning the filter, you can wipe it with a clean cotton
cloth to remove larger foreign matter. Then use a soft-bristled
brush to gently remove dust. Brush lightly from top to bottom. Do
not use excessive force to avoid damaging the bristles. For items
that are difficult to clean, use bottled gas or a spray gun to
remove dust. At this time, keep a certain distance and don't spray
too much.
5. Install the filter
Reinstall the cleaned filter back into the projector. If you find
that there is still dust on the filter, you need to clean it again.
To sum up, cleaning the projector filter is relatively simple, but
you must pay attention to safety and gentleness, and do not use too
rough methods to clean, so as not to affect the service life. The
frequency of cleaning the projector filter can be determined
according to actual conditions. Cleaning is recommended at least
quarterly. It can also be determined based on the intensity of
daily use to ensure the normal operation of the machine and improve
the projection effect.
